Failure analysis of breakage in A4 paper cutter

 The up and down movement of our A4 paper cutter bed Guo Zengzhong mainly relies on its lever with an adapter sleeve to trigger its action. To ensure the safety of the machine in the event of accidental overload, we can configure it on its lever Correspondingly secure pin parts. But sometimes when our cutting action resistance value is large, cracking will occur in its stable sale. At this time, to ensure the safety of its machine and other corresponding parts, we should stop its cutting operation immediately.
Sometimes when we use the A4 paper cutter to cut some discarded standard paper, due to the unevenness of each stack of paper, it is too full during its horizontal placement, and it is too close to its right wall board. At this time, when we cut it, its knife will cause cracking in an instant due to its excessive resistance value. At this time, we can only replace the parts accordingly, but in fact, it is also a troublesome to replace the parts when the machine is stopped.
Therefore, in order to avoid the above-mentioned accidents and to avoid unnecessary troubles, we should pay special attention to their high consistency while cutting some narrow paper reeds, and keep them not too close to them. Right wall panel.