The forming wire is an important part of the forming device on the paper machine. It is driven by a flat roller or other driving rollers, so that the pulp is continuously filtered and dehydrated on the net to form a wet paper layer, and the wet paper layer is transported to the flat roller.

The press type and number of passes in the press section of a paper machine are selected according to the dewatering characteristics determined by the ratio of the raw materials of the paper and certain quality requirements of the paper

The development of the dryer section of the paper machine:1. Single dry blanket drying device of paper machineThe drying section of a traditional multi-cylinder paper machine is equipped with two upper and lower drying cylinders with double blankets.

We all know that the wet end of a paper machine is easy to break. Therefore, the water filtering capacity of the pulp and the dewatering capacity of the paper machine itself have always been the focus of people’s attention. Let's take a look at the possible causes of paper breaks in the dryer section.

Requirements for lubricating oil in various parts of paper machineThe modern paper machine is a behemoth with a high degree of integration, including four main parts: the forming part or the wire part, the pressing part, the drying part, and the rewinding part.

As the paper machine is developing in the direction of large-scale, continuous, and automated, the paper machine's width and paper output speed have been greatly improved, and the bearing speed has increased correspondingly. More and more paper machine customers have begun to choose lubrication in the entire system.