Vibration screen can be used to screen out large particles and pulverize powdery materials. Before use, it is necessary to check whether the screen of the equipment is damaged, whether it is necessary to add lubricating oil to the vibration motor, it must be turned on before each use, and the machine should be rotated for five minutes after normal operation Feeding, do not feed too much or too little, maintain uniform feeding, continuous non-feeding will cause damage to the screen, the following is the common fault detection and maintenance instructions on the Vibration screen for users’ reference
Vibrating screen is one of the commonly used screening equipment. It has the advantages of high screening efficiency, high screening quality and large processing capacity, and is favored by customers. Then the following analysis and solutions are given for the problems that may occur in the screening process of the vibrating screen.
After the vibrating screen is used for a period of time, grease or dirt will adhere to the surface. If it is not cleaned in time, the screen will rust. Therefore, the impurities on the screen should be cleaned up in time after using the vibrating screen. It can be cleaned with soap, warm water or weak detergent. If there is oily dirt, you can wipe it with a soft cloth and then wash it with detergent. If there is rust on the surface of the vibrating screen, it can be cleaned with nitric acid or other derusting acids; if rainbow patterns appear, it can be cleaned with neutral detergent in warm water.
Many customers' vibrating screens are usually produced in the open air, so the screen of the vibrating screen is usually rusty due to rain, humidity and other reasons. What should I do if the screen of the vibrating screen is rusted, and how to prevent and remove rust? This time I mainly share three points of knowledge in this area:
Because the vibrating screen is affected by various environments and materials on site, coupled with the characteristics of the mechanical product itself (limited service life), it is inevitable to repair the vibrating screen. More importantly, the maintenance of the vibrating screen has a direct impact The quality of the products screened out, therefore, the accurate maintenance and maintenance of the vibrating screen is particularly important. Vibrating screen manufacturer Guosheng Machinery, teach you how to maintain and maintain the vibrating screen!
Vibration screen can be used to screen out large particles and pulverize powdery materials. Before use, it is necessary to check whether the screen of the equipment is damaged, whether it is necessary to add lubricating oil to the vibration motor, it must be turned on before each use, and the machine should be rotated for five minutes after normal operation Feeding, do not feed too much or too little, maintain uniform feeding, continuous non-feeding will cause damage to the screen, the following is the common fault detection and maintenance instructions on the Vibration screen for users’ reference