The shaft head of the dryer cylinder​ of the paper machine company sometimes has abrasion problems. Under normal circumstances, the company chooses to replace the bearing and will continue to operate,

The main components of the dryer cylinder​ are steam joints and spoilers.Steam needs to be passed through the dryer cylinder, and the condensed water inside needs to be drained. But the drying cylinder is a rotating cylinder, so a special joint is needed to complete this task, that is, the steam joint.

The common problem of dryer cylinder​ is the wear of the dryer cylinder shaft head. Due to the high temperature and pressure of the drying cylinder during operation, the shaft head of the drying cylinder is prone to wear and tear, causing the equipment to fail to operate.

The dryer cylinder​ is a hollow cylinder made of cast iron with covers at both ends. It is composed of a cylinder body and cylinder heads at both ends. The outer diameter is usually 1000～3000mm. During operation, the conveyed paper will be dried by internal steam. Burned.

The so-called Dryer Cylinder seems to be very simple, like a large iron bucket, but in fact its main body is a round hollow tree made of cast iron, which is heated by steam inside, and when the outside reaches a certain temperature. , You can dry the newly produced paper.

Dryer cylinder is a relatively important equipment in the paper industry. The newly produced paper needs to be dried and flattened before it can be shaped.